Latest revision as of 00:37, 23 March 2016

Visual Inventory Sheets

These sheets were used for people picking their own parts during the workshop, from containers separated by modules:

It took 10 hours to unpack 12 Folgertech Kits:

@@ Line 1: / Line 1: @@
+=Visual Inventory Sheets=
+These sheets were used for people picking their own parts during the workshop, from containers separated by modules:
+[[Image:visinvent3e.jpg]]
+[https://drive.google.com/a/opensourceecology.org/folderview?id=0ByRPBiXEVh2hWGNzTjNWNWdLbHM&usp=sharing_eid&ts=56f1e3ca Source files in GIMP/Illustrator]:
 =Unpacking=
-It took 10 hours to unpack 12 printers:
+It took 10 hours to unpack 12 [[Folgertech Kit]]s:
 #Separate bolts by size
 #Separate every part by one of 10 Modules as at [[Prusa i3 Build Optimization]]
+=Further Prep=
+#Put set screws into L brackets (24 set screws per machine)
+#Separate aluminum beams and unwrap, then tape together into a bunch
+#Take bags off all aluminum bushing blocks
+#Put on jumpers onto controller boards
+#Put on stepper drivers onto controllers
+#Bend up the transistors on stepper drivers
+#Take backing off all plexiglas
+#Wiring bundle - separate wires
+#One pair of 22 ga thin wires goes to extruder
+#Long piece of 16 ga wires goes to heated bed box
+#2 pairs of 7" 16 ga wire go to power supply
+#Female end of power plug is cut
+#Strip 2" off power plug end, strip off 2 cm off individual wires
+=Final Prep=
+#Upload control code to controller
+#Create Live Linux USBs
+#Prepare Inventory Cheat Sheets for workshop
+#Solder the height probe diode and tin wire ends
+#Prepare aluminum plates