D3D Inventory: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
=Visual Inventory Sheets= | |||
These sheets were used for people picking their own parts during the workshop, from containers separated by modules: | |||
[[Image:visinvent3e.jpg]] | |||
[https://drive.google.com/a/opensourceecology.org/folderview?id=0ByRPBiXEVh2hWGNzTjNWNWdLbHM&usp=sharing_eid&ts=56f1e3ca Source files in GIMP/Illustrator]: | |||
=Unpacking= | =Unpacking= | ||
It took 10 hours to unpack 12 [[Folgertech Kit]]s: | It took 10 hours to unpack 12 [[Folgertech Kit]]s: | ||
| Line 13: | Line 23: | ||
#Bend up the transistors on stepper drivers | #Bend up the transistors on stepper drivers | ||
#Take backing off all plexiglas | #Take backing off all plexiglas | ||
#Wiring bundle - separate wires | |||
#One pair of 22 ga thin wires goes to extruder | |||
#Long piece of 16 ga wires goes to heated bed box | |||
#2 pairs of 7" 16 ga wire go to power supply | |||
#Female end of power plug is cut | |||
#Strip 2" off power plug end, strip off 2 cm off individual wires | |||
=Final Prep= | |||
#Upload control code to controller | |||
#Create Live Linux USBs | |||
#Prepare Inventory Cheat Sheets for workshop | |||
#Solder the height probe diode and tin wire ends | |||
#Prepare aluminum plates | |||
Latest revision as of 00:37, 23 March 2016
Visual Inventory Sheets
These sheets were used for people picking their own parts during the workshop, from containers separated by modules:
Source files in GIMP/Illustrator:
Unpacking
It took 10 hours to unpack 12 Folgertech Kits:
- Separate bolts by size
- Separate every part by one of 10 Modules as at Prusa i3 Build Optimization
Further Prep
- Put set screws into L brackets (24 set screws per machine)
- Separate aluminum beams and unwrap, then tape together into a bunch
- Take bags off all aluminum bushing blocks
- Put on jumpers onto controller boards
- Put on stepper drivers onto controllers
- Bend up the transistors on stepper drivers
- Take backing off all plexiglas
- Wiring bundle - separate wires
- One pair of 22 ga thin wires goes to extruder
- Long piece of 16 ga wires goes to heated bed box
- 2 pairs of 7" 16 ga wire go to power supply
- Female end of power plug is cut
- Strip 2" off power plug end, strip off 2 cm off individual wires
Final Prep
- Upload control code to controller
- Create Live Linux USBs
- Prepare Inventory Cheat Sheets for workshop
- Solder the height probe diode and tin wire ends
- Prepare aluminum plates