File:D3DOriginal config.ini: Difference between revisions
Jump to navigation
Jump to search
(Marcin uploaded a new version of File:D3DOriginal config.ini) |
(Marcin uploaded a new version of File:D3DOriginal config.ini) |
| (2 intermediate revisions by the same user not shown) | |
(No difference)
| |
Latest revision as of 02:56, 20 June 2017
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Dimensions | User | Comment | |
|---|---|---|---|---|
| current | 02:56, 20 June 2017 | (10 KB) | Marcin (talk | contribs) | Working version for production printing. Z offset is ~0, it doesn't appear to work. Z offset is set in hardware by single probing to determine 100 microns above print surface. PLA setting, 1.75mm, 205C nozzle and 60C bed. |
| 18:40, 10 June 2017 | (10 KB) | Marcin (talk | contribs) | OSE Lulzbot Cura settings with OSE Marlin: Max Z feed rate increased from 5 to 10 mm/s via M203 in Start GCode Travel speed reduced from 150 to 80 mm/s in Advanced Settings Infill speed reduced from 80 to 50 mms/s in Advanced Settings | |
| 04:40, 10 June 2017 | (10 KB) | Marcin (talk | contribs) | Turns extruder heater and bed heater off. | |
| 04:33, 10 June 2017 | (10 KB) | Marcin (talk | contribs) | Overrides Extruder Steps per mm setting of OSE Marlin with M92 E100 - or 100 extruder steps per mm of filament. This was measured using 1.75 mm PLA filament in D3D Original 16". | |
| 22:18, 9 June 2017 | (10 KB) | Marcin (talk | contribs) | Added: set bed to standby temperature, and set extruder to 100C. | |
| 21:17, 9 June 2017 | (9 KB) | Marcin (talk | contribs) | Set filament to 1.75mm and temperature to 205 for PLA. Bed is 60. | |
| 21:07, 9 June 2017 | (9 KB) | Marcin (talk | contribs) |
You cannot overwrite this file.
File usage
The following 3 pages use this file: