Steam Engine Build/Valve: Difference between revisions
Jump to navigation
Jump to search
(Created page with "{{Category=Steam Engine}} =Description= The valve controls the flow of steam from the steam chest to the cylinder bore. Steam is admitted into the cylinder just before top dea...") |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
{{Category=Steam Engine}} | {{Category=Steam Engine}} | ||
[[Steam Engine Build Instructions]] | |||
=Description= | =Description= | ||
| Line 6: | Line 8: | ||
Two valves are needed. | Two valves are needed. | ||
=CAD= | |||
[[Image:cad-valve-1.png]][[Image:cad-valve-2.png]] | |||
=Drawing= | =Drawing= | ||
[[Image: | [[Image:Spec-Valve-2.png]] | ||
=Instructions= | =Instructions= | ||
| Line 15: | Line 21: | ||
'''Materials:''' | '''Materials:''' | ||
* 2. | * 2.0" steel round stock, about 2.0" long. | ||
'''Fabrication''' | '''Fabrication''' | ||
# Mount the stock in a metal lathe | # Mount the stock in a metal lathe | ||
# Reduce the valve | # Reduce the valve stem to 1.24" diameter for a length of 1.03" | ||
# Machine a 45 degree bevel to form the valve head. | # Machine a 45 degree bevel to form the valve head. | ||
# | # Outer diameter of the valve head is 2.0". | ||
# | # Valve head should be 0.8" long. | ||
# Polish the valve head point. | # Polish the valve head point. | ||
# Polish the valve tail so that it may move freely in the valve hole of the valve cover. | # Polish the valve tail so that it may move freely in the valve hole of the valve cover. | ||
Latest revision as of 14:06, 2 July 2011
Main > Energy > Steam Engine
Steam Engine Build Instructions
Description
The valve controls the flow of steam from the steam chest to the cylinder bore. Steam is admitted into the cylinder just before top dead center of the stroke cycle. One end of the valve is conical in shape (45 degree) machined to match the valve seat. In the middle of the valve stem, the valve diameter is reduced to slide freely inside the valve hole of the valve cover. At the other end, the diameter is further reduced to fit inside the valve spring.
Two valves are needed.
CAD
Drawing
Instructions
Materials:
- 2.0" steel round stock, about 2.0" long.
Fabrication
- Mount the stock in a metal lathe
- Reduce the valve stem to 1.24" diameter for a length of 1.03"
- Machine a 45 degree bevel to form the valve head.
- Outer diameter of the valve head is 2.0".
- Valve head should be 0.8" long.
- Polish the valve head point.
- Polish the valve tail so that it may move freely in the valve hole of the valve cover.