Folgertech Kit: Difference between revisions
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
=Improvements= | =Improvements= | ||
The main improvement that we will make is adding automatic bed leveling. | |||
#'''Note: correction needs to be made based on the top 2 posts here - on end stop plug in location and change in firmware. [http://forums.reprap.org/read.php?406,512329,569248#msg-569248]. This Github note [https://github.com/therippa/Marlin] appears to say the same thing. Further, the first link also states that the firmware is outdated - outside of hte xmax issue mentioned. | |||
#Upgrade firmware, including auto bed level with inductive sensor - [http://www.tested.com/tech/3d-printing/561787-testing-folger-tech-2020-i3-3d-printer/] | |||
#Anti-backlash nut case and belt tensioner - [http://www.thingiverse.com/thing:694575] | |||
#Improvements on Thingiverse - auto level, cable chain, endstop improvements, etc. - [http://www.thingiverse.com/QuadBert/collections/folger-tech-2020-prusa-i3/] | |||
#X endstop replacement - [http://www.thingiverse.com/thing:1225266] | |||
=Other Instructionals= | =Other Instructionals= | ||
*Reddit thread on building FPi3 - [https://www.reddit.com/r/Reprap/comments/42vpku/i_recently_ordered_a_folgertech_prusa_i3_2020_and/] | *Reddit thread on building FPi3 - [https://www.reddit.com/r/Reprap/comments/42vpku/i_recently_ordered_a_folgertech_prusa_i3_2020_and/] | ||
*Github Community Folgertech Prusa i3 documentation - [https://github.com/cyberkni/FolgertechManuals/blob/master/2020i3/README.md]. No alignment procedure mentioned. | *Github Community Folgertech Prusa i3 documentation - [https://github.com/cyberkni/FolgertechManuals/blob/master/2020i3/README.md]. No alignment procedure mentioned. | ||
Revision as of 06:09, 31 January 2016
Source
- See [1]
Build Results
Build Pictures
See Folgertech Prusa i3 Google Drive].
Improvements
The main improvement that we will make is adding automatic bed leveling.
- Note: correction needs to be made based on the top 2 posts here - on end stop plug in location and change in firmware. [2]. This Github note [3] appears to say the same thing. Further, the first link also states that the firmware is outdated - outside of hte xmax issue mentioned.
- Upgrade firmware, including auto bed level with inductive sensor - [4]
- Anti-backlash nut case and belt tensioner - [5]
- Improvements on Thingiverse - auto level, cable chain, endstop improvements, etc. - [6]
- X endstop replacement - [7]