Tobbens Adding Inductive Proximity Sensor Log: Difference between revisions
Jump to navigation
Jump to search
(Created page with "= Introduction = This page documents adding a Research_On_Inductive_Proximity_Sensors#LJ12A3-4-Z.2FBX LJ12A3-4-Z/BX inductive proximity sensor to a Folgertech 2020 Prusa i...") |
(→Theory) |
||
| Line 7: | Line 7: | ||
= Theory = | = Theory = | ||
The sensor if of NPN type and normally open. We will feed it with 12 V | The sensor if of NPN type and normally open. We will feed it with 12 V. Therefore we expect the following two states: | ||
[[Image:Triggered_ZJ12A3-4-ZBX.svg|none|center| | [[Image:Triggered_ZJ12A3-4-ZBX.svg|none|center|400x200px]] | ||
[[Image:Untriggered_ZJ12A3-4-ZBX.svg|none|center|400x200px]] | |||
Revision as of 13:27, 6 March 2016
Introduction
This page documents adding a Research_On_Inductive_Proximity_Sensors#LJ12A3-4-Z.2FBX LJ12A3-4-Z/BX inductive proximity sensor to a Folgertech 2020 Prusa i3. Printer assembly up until this point is documented in Tobbens_Folgertech_Kit_Unboxing_Log and Tobbens_Folgertech_Kit_Assembly_Log. Not documented there is only the addition of an aluminum plate on top of the heat bed, like shown in the pictures below:
Theory
The sensor if of NPN type and normally open. We will feed it with 12 V. Therefore we expect the following two states:
