D3D Controller: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
Line 11: Line 11:


=Code=
=Code=
*Start with [[OSE Folgertech Prusa i3 Marlin]] - [[File:OSE_Marlin.zip]]
See [[D3D Marlin]]
*The firmware code which is uploaded to the control Arduino (part of RAMPS) is a bunch of files contained in a folder, totaling 1.5 MB. The main file for configuration is configuration.h. When using the [[Arduino Environment]], load Marlin.ino when opening new file. This will open up the whole bunch of Marlin files. To upload to RAMPS - use a USB cord.
:*To upload, make sure you have Serial Port selected in Tools, and correct Board selected.
:*Upload did not work for MJ until I disconnected the 3D Printer - might have been wrong port selected.

Revision as of 21:17, 13 March 2017

BOM

edit

Wiring

Code

See D3D Marlin

Retrieved from "https://wiki.opensourceecology.org/index.php?title=D3D_Controller&oldid=149202"