D3D Controller: Difference between revisions
Jump to navigation
Jump to search
(→Code) |
(→Code) |
||
| Line 6: | Line 6: | ||
=Code= | =Code= | ||
Download code at [[D3D Marlin]]. You can upload to your board using the [[Arduino Environment]]. | Download code at [[D3D Marlin]]. You can upload to your board using the [[Arduino Environment]]. | ||
=Machine Control]] | |||
You can download and install [[Lulzbot Cura]] to run D3D. We have a configuration file that you can load in Cura. Cura shows the control window only after you load a print file, such as the [[10mm Cube]] | |||
=RAMPS Wiring= | =RAMPS Wiring= | ||
Revision as of 02:24, 3 May 2017
Wiring
Code
Download code at D3D Marlin. You can upload to your board using the Arduino Environment.
=Machine Control]] You can download and install Lulzbot Cura to run D3D. We have a configuration file that you can load in Cura. Cura shows the control window only after you load a print file, such as the 10mm Cube
RAMPS Wiring
- For RAMPS wiring detail, see Prusa i3 Build Optimization