D3D Controller: Difference between revisions
Jump to navigation
Jump to search
(→Code) |
(→Code) |
||
| Line 8: | Line 8: | ||
=Machine Control]] | =Machine Control]] | ||
You can download and install [[Lulzbot Cura]] to run D3D. We have a configuration file that you can load in Cura. Cura shows the control window only after you load a print file, such as the [[ | You can download and install [[Lulzbot Cura]] to run D3D. We have a configuration file that you can load in Cura. Cura shows the control window only after you load a print file, such as the [[10 mm Cube]] | ||
=RAMPS Wiring= | =RAMPS Wiring= | ||
Revision as of 02:24, 3 May 2017
Wiring
Code
Download code at D3D Marlin. You can upload to your board using the Arduino Environment.
=Machine Control]] You can download and install Lulzbot Cura to run D3D. We have a configuration file that you can load in Cura. Cura shows the control window only after you load a print file, such as the 10 mm Cube
RAMPS Wiring
- For RAMPS wiring detail, see Prusa i3 Build Optimization