Talk:Oliver Log: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
Line 21: Line 21:


what about mechanical probing ?  https://www.indiegogo.com/projects/bltouch-auto-bed-leveling-sensor-for-3d-printers#/
what about mechanical probing ?  https://www.indiegogo.com/projects/bltouch-auto-bed-leveling-sensor-for-3d-printers#/
Answer: probably not well suited because of the heat.


--
Master-thesis on capacitive sensors:  [[repository.tudelft.nl/islandora/object/uuid:e2234250-950d-4eb5-9f2e-b5b8e67af2e5/datastream/OBJ/download]]


= '''Mon, May,22,2017''' =
= '''Mon, May,22,2017''' =

Revision as of 06:29, 24 May 2017

Tue, May,23,2017

Some links related to the torchtable height controler:

Working document [1] AD7747 [2] Dummy page (?) [3] Pauls log [4]

---

Trying to re-use Pauls KiCad-Files run into the problem of beeing an older Version, what means all links are broken, see all the question marks in

This is a known problem and theoretically there exists a way to fix it, see https://rheingoldheavy.com/new-stable-kicad-10-steps-to-import-an-old-kicad-project/, but its way to complicated to go through this procedure. Meaning, since Pauls circuit is not too complicated its probably far less work to simply rebuild it from scratch.

---

what about mechanical probing ? https://www.indiegogo.com/projects/bltouch-auto-bed-leveling-sensor-for-3d-printers#/ Answer: probably not well suited because of the heat.

--

Master-thesis on capacitive sensors: repository.tudelft.nl/islandora/object/uuid:e2234250-950d-4eb5-9f2e-b5b8e67af2e5/datastream/OBJ/download

Mon, May,22,2017

Preparation for torchtable-workgroup meeting on 23.05.:

Suggestions for the long axis:


- supportet Rails [5] would be nice for better stiffness and rigidity, . Makes a price difference of about 20,- EUR or less per m .

* Instead of one 1"-shaft we could use two 1/2"-shafts to resemble the recent unversal axis design as is.
* Or instead we can use just one 1"-shaft and place the stepper onto the carriage (like shapeoko) 
  ==> simplyfied end-pieces (they are only needed to fix the belt).



- Universal Controler: Powerlolu as stepperdriver for heavier loads ?

* Was already discussed on OSE in 2013, see [6]
* sources are available at 
  GitHub [7] and 
  Upverter [8] and
  Allegro [9] and
  Cuteminds [10] and
  Balestrino [11].  
* new breakout board from OSH park at [12]
* I tested them already [13] [14] in combination with RAMPS and so far they seemed to work well.