D3D v18.06: Difference between revisions
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
*First, select the right board | *First, select the right board | ||
*Second, select the right port | *Second, select the right port | ||
*Possible errors: permission denied | *Possible errors: permission denied while using OSE Linux. This should not happen by default. Let's check if other linux has this issue. | ||
avrdude: ser_open(): can't open device "/dev/ttyUSB0": Permission denied | avrdude: ser_open(): can't open device "/dev/ttyUSB0": Permission denied | ||
Revision as of 02:15, 6 June 2018
Development Template
Software Notes
- Uploading to Arduino can be tricky.
- First, select the right board
- Second, select the right port
- Possible errors: permission denied while using OSE Linux. This should not happen by default. Let's check if other linux has this issue.
avrdude: ser_open(): can't open device "/dev/ttyUSB0": Permission denied ioctl("TIOCMGET"): Inappropriate ioctl for device ioctl("TIOCMGET"): Inappropriate ioctl for device avrdude: ser_send(): write error: Bad file descriptor Problem uploading to board. See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
Build
Hint: Click on Facebook post, then navigate to the OSE Workshops FB Page to access pictures of 47 steps from the original posting