3D Printer Stops Midprint: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
*Might be bad SD card - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | *Might be bad SD card - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | ||
*Reinstalling Cura helped - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | *Reinstalling Cura helped - [https://www.reddit.com/r/3Dprinting/comments/akvj0k/ender_3_stopping_mid_printhow_do_i_stop_this/] | ||
*New Cura has bugs - [https://community.ultimaker.com/topic/23972-new-version-of-cura-stops-printing-mid-job/] | |||
Revision as of 23:36, 20 July 2019
- Typically this is a slicer error where spurious results happen from slicing - reslice and try again. Just moving the object on the bed may help.
- Thermal cutout on extruder motor - last issue at [1]
- Obvious ones - filament ran out, broke, or stripped - [2]
- m600 m410 m125 m0 or many of the other commands that could be triggering the same or similar pause states. - see [3]
- Might be bad SD card - [4]
- Reinstalling Cura helped - [5]
- New Cura has bugs - [6]