Quality Control: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 2: | Line 2: | ||
*D3D 19.06 - Y2 axix must be constrained only in the Y direction, not X, since that is the auto parallel. The implication is that the linear bearings on Y2 can be loose in the X direction, but not in the Y direction | *D3D 19.06 - Y2 axix must be constrained only in the Y direction, not X, since that is the auto parallel. The implication is that the linear bearings on Y2 can be loose in the X direction, but not in the Y direction | ||
*Just one electric tape layer around bearing could overtighten the bearings, while without this layer the bearings could be perfectly smooth. | *Just one electric tape layer around bearing could overtighten the bearings, while without this layer the bearings could be perfectly smooth. | ||
*Y carriage upper bolts are inaccessible without a nut holder tool. Move axis away from frame? | |||
Revision as of 02:48, 1 September 2019
Sat Aug 31, 2019
- D3D 19.06 - Y2 axix must be constrained only in the Y direction, not X, since that is the auto parallel. The implication is that the linear bearings on Y2 can be loose in the X direction, but not in the Y direction
- Just one electric tape layer around bearing could overtighten the bearings, while without this layer the bearings could be perfectly smooth.
- Y carriage upper bolts are inaccessible without a nut holder tool. Move axis away from frame?