Revision as of 06:28, 10 April 2020

Specifications

Notes:

Fiberglass sleeve used - HTG fiberglass, does not fray like standard high temperature sleeving (1000F) and is rated for . See [1]. Note that the resin can burn out at the 650C (1200F) workign temp. Sleeve has VW-1 flame resistance. Made of fiberglass, it does not burn out, but may fuse and lose fiber structure.
Inner core: 5' long wraparound of 2mm tight braid fiberglass sleeve - 600C - [2]. Started with 5', wrap was more like 4' long.
This is packed into 4' of 6 mm tight braid fiberglass sleeve.
Fence wire is used to couple 200C wire to nichrome, in order not to burn out 200C wire. Nichrome is wrapped around the fence wire 5-10 turns
Copper wire is soldered to the fence wire.
10" end piece of 6 mm tight braid sleeve covers the 200C wire, fence wire, and ends of nichrome.
2 strands of nichrome heater element are made, each 14' long, each about 600W.
Ends, covered by 6 mm tight braid sleeve - stick out the finished bed. Third wire set is the thermistor, which is wrapped with 2 mm tight braid so it doesn't melt out.

Theoretical idea:

But, ga 18 can't bend easily using a cordless drill.

20 feet of 20 ga wire appears to be most convenient - 1 piece, max at 1200F. Current 500W heater is 1200F max, and works well.

14 feet of 24 ga works perfectly by hand to get a good wrap over 4 feet, and goes fast, about 1 minute pending tieups:

Cut 14' of ga 24 nichrome
Cut 5' of tight 2 mm fiberglass sleeve
start the wrap of nichrome on one end of sleeve
Attach other end of sleeve to a free-spinning rotor
Once enough to go inside a cordless drill chuck - grab the nichrome wrap and turn on the drill in reverse to start wrapping. Tension the sleeve against the rotor
Wrap away! A person should be able to wrap 4 feet long just by holding a corless drill

@@ Line 58: / Line 58: @@
 [[File:actualwrap.png|500px]]
-=Heater Element Build Procedure=
+=Heater Element Wrapping Procedure=
 #Cut 14' of ga 24 nichrome
 #Cut 5' of tight 2 mm fiberglass sleeve