D3D v20.04.27 Build Instructions: Difference between revisions
Jump to navigation
Jump to search
(→Z Axis) |
(→Z Axis) |
||
| Line 5: | Line 5: | ||
#Assemble idler side. | #Assemble idler side. | ||
#Mount idler side on bottom of frame, with nuts next to frame. | #Mount idler side on bottom of frame, right next to corner piece, with nuts next to frame. | ||
#Assemble carriage side. | #Assemble carriage side. | ||
#Open idler side, keeping it mounted on frame. This will allow fitting of axis to it. | #Open idler side, keeping it mounted on frame. This will allow fitting of axis to it. | ||
| Line 11: | Line 11: | ||
#Fit motor side to frame, hanging it on the top of the frame, and adjusting rod lengths so they are slightly above the working surface. | #Fit motor side to frame, hanging it on the top of the frame, and adjusting rod lengths so they are slightly above the working surface. | ||
#Take off axis, mount motor, tighten motor side fully. | #Take off axis, mount motor, tighten motor side fully. | ||
#Mount motor side | #Mount motor side on frame, and in idler. | ||
#Close the idler side. | |||
#One axis mounted. Now mount 3 more. | |||
=Links= | =Links= | ||
*[[D3D v20.04.27]] | *[[D3D v20.04.27]] | ||
Revision as of 04:16, 1 May 2020
Bed
Z Axis
- Assemble idler side.
- Mount idler side on bottom of frame, right next to corner piece, with nuts next to frame.
- Assemble carriage side.
- Open idler side, keeping it mounted on frame. This will allow fitting of axis to it.
- Mount motor side on rods, keep loose.
- Fit motor side to frame, hanging it on the top of the frame, and adjusting rod lengths so they are slightly above the working surface.
- Take off axis, mount motor, tighten motor side fully.
- Mount motor side on frame, and in idler.
- Close the idler side.
- One axis mounted. Now mount 3 more.