Lathe Safety Simulator: Difference between revisions
Jump to navigation
Jump to search
(Added some more links under the "Internal Links" section) |
(Minor Clarification) |
||
| Line 1: | Line 1: | ||
=Basics= | =Basics= | ||
*A VR Training Game/Software for an Industrial Metal lathe | *A Free VR Training Game/Software for an Industrial Metal lathe | ||
= [[User: Eric]] 's bit on it = | = [[User: Eric]] 's bit on it = | ||
Latest revision as of 23:12, 8 May 2021
Basics
- A Free VR Training Game/Software for an Industrial Metal lathe
User: Eric 's bit on it
Bad Aspects
- It has a sort of unpolished "Half Life 1/2" kind of feel to it (also some of the audio effects were the same for objects hitting each other which was funny)
- The interface was a bit clunky at times (if instructions were missed / an error was made there wasn't a way (unless i missed it, which is a possibility) to go back or repeat the instructions)
- The locomotion was very limited (it only allowed for the press to teleport to selected area method)
Good Aspects
- Rather than make a detailed small dial, it used a HUD little pop-up bubble as the indicator for the amount of mm / degrees something was set to
- It was simple to follow, and very detailed (granted some parts, such as the motor switchboard, weren't very visually detailed/accurate short of maybe the E-Stop)
- Because it was so simple attempting to make something to a similar level would be easier than other examples