PV Panel Grounding

NEC 690 - Covers PV Systems

• 690.41 - Equipment Grounding Conductor requirements [1]
  • 690.41(B) also requires ground fault protection except if there are no more than 2 strings (PV source circuits [2])
    • Since NEC 2020, ground fault indicator must be readily visible (but not necessarily readily accessible?) [3]
  • 690.45 - size of PV equipment grounding conductors - Table 250.122 + no less than 14 ga.
• 690.9(A) says that we don't need overcurrent device for PV if the wires can handle short current capacity of PV. But good luck trying to convince a code official.
• PV Grounding PDF [4]. Although the NEC does not specifically require all equipment to be certified/listed, many local jurisdictions and many AHJs establish requirements that all equipment be certified/listed because they feel unqualified to examine uncertified/unlisted equipment for safety as the NEC requires.
  • Good overview doc. Read it from p. 6 on to understand equipment ground, system ground.
  • Additional issue for PV is that in cloudy conditions, if you get a fault, a breaker may not trip because current is too low. For this reason, extra ground fault protection devices may be required.
• Is earth ground of a PV system connected to DC negative, or to AC neutral?

Ground Faults - System Grounding Howto

• Article says that a common ground fault protection device (GFPD) is a fuse to ground - [5]
• NEC Article 690.41 states that grounding for photovoltaic systems includes 2 grounds [6]:
  • The first one is system grounding: the PV system with system voltage over 50 volts should be solidly system-grounded.
  • The other one is the equipment grounding: the exposed non-currentcarrying metal parts of PV module frames, electrical equipment, and conductor enclosures should be grounded .
• System Ground Howto: To achieve that, the negative conductor usually is grounded via the GFPD in the PV inverter at point G [7]:

More

• Solar PV standards and certifications - [8]. Class II means frames grounded, no system ground.

• Paper on PV grounding, 1984. Fire safety and personnel safety are typically tradeoffs? [9]
  • Solidly grounded means neutral is connected to earth electrode. [10]
  • Class II system had double insulation and equipment ground, but no earth connection.
  • Class I has equipment ground and earth connection.
  • Insulation failures between current-carrying conductors and the ground are known as ground faults.
• Classic video by Mike Holt. Equipment Grounding + system grounding - Ground and grounding electrode conductor basic with Mike Holt - [11]
  • Do not earth ground frames with a ground rod like this - [12]

Equipment Grounding

• PV panels should follow electrical grounding conductor sizes - [13]
• Ie, for 30A DC, we need 10 ga ground.
• PV frames must be connected to PV system equipment grounding conductor [14]
• After leaving the PV array, the equipment ground must run together with the power wires. [15]

What Size Grounding Conductor on PV Panels?

• Australia rules - appear to say 6 ga for lightning protection, and 12 ga for frame grounding [16]
• 6 ga USA if 'subject to damage'?