Build Fuel Tank: Difference between revisions
Jump to navigation
Jump to search
(Created page with "*Cut 1/4"x4"x8*fuel tank with cold cut saw, band saw, or torch *[2] Cut tank ends - 1/4"x4"x8" flats *Spray paint patter of filler cap ontop *Torch filler cap hole *Drill screw ...") |
No edit summary |
||
| Line 1: | Line 1: | ||
*Cut 1/4"x4"x8*fuel tank with cold cut saw, band saw, or torch | *Cut 1/4"x4"x8*fuel tank with cold cut saw, band saw, or torch | ||
*Clean edges, clean out inside of debris | |||
*[2] Cut tank ends - 1/4"x4"x8" flats | *[2] Cut tank ends - 1/4"x4"x8" flats | ||
*Spray paint | *Spray paint pattern of filler cap on top tank closure | ||
*Torch filler cap hole | *Torch filler cap hole | ||
*Drill screw holes for filler cap | *Drill screw holes for filler cap | ||
* | *Fuel line is located at middle bottom of 8" face of tank - torch it out | ||
* | *Cut a 1/4" fitting for fuel line | ||
*Weld fuel | *Grind and ream all edges to be welded prior to welding | ||
*Weld fuel line fitting (1/4" npt) | |||
*Weld bottom and top onto fuel tank | *Weld bottom and top onto fuel tank | ||
[[Category:Fabrication Procedures]] | [[Category:Fabrication Procedures]] | ||
Revision as of 22:23, 18 June 2011
- Cut 1/4"x4"x8*fuel tank with cold cut saw, band saw, or torch
- Clean edges, clean out inside of debris
- [2] Cut tank ends - 1/4"x4"x8" flats
- Spray paint pattern of filler cap on top tank closure
- Torch filler cap hole
- Drill screw holes for filler cap
- Fuel line is located at middle bottom of 8" face of tank - torch it out
- Cut a 1/4" fitting for fuel line
- Grind and ream all edges to be welded prior to welding
- Weld fuel line fitting (1/4" npt)
- Weld bottom and top onto fuel tank