Assemble Power Cube: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
*Weld frame using jig. | *Weld frame using jig. | ||
*Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube. | *Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube. | ||
* | *Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame. | ||
*Cut shaft | |||
[[Category:Fabrication Procedures]] | [[Category:Fabrication Procedures]] | ||
Revision as of 00:41, 19 June 2011
- Weld frame using jig.
- Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube.
- Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame.
- Cut shaft