Assemble Power Cube: Difference between revisions

Revision as of 00:44, 19 June 2011

Weld frame using jig.
Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube.
Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame.
Mount Engine and Pump:
- Trim engine shaft to 2"
Put fittings on hydraulic pump
- [1] Cut plate for Engine Mount - 1/4"x8"x20"?
- [1] Cut plate for hydraulic pump - 1/4"x8"x?
- [1] Cut 1/4"x8"x3"? connecting plate
- [1] Cut 1/4"x2" angle for Power Cube Mount
- Torch engine mount plate - best is plasma cutter
- Torch hydraulic pump plate
- Adjust height of angle to allow hydraulic pump to stick 1" above bottom plane of the Power Cube
- Tack weld angle to frame and mount plates to hydraulic tank
- Place engine in position
- Attach lovejoy coupler to engine

@@ Line 2: / Line 2: @@
 *Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube.
 *Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame.
-*[[Mount Engine and Pump]]
+*[[Mount Engine and Pump]]:
+**Trim engine shaft to 2"
+*Put fittings on hydraulic pump
+**[1] Cut plate for Engine Mount - 1/4"x8"x20"?
+**[1] Cut plate for hydraulic pump - 1/4"x8"x?
+**[1] Cut 1/4"x8"x3"? connecting plate
+**[1] Cut 1/4"x2" angle for Power Cube Mount
+**Torch engine mount plate - best is plasma cutter
+**Torch hydraulic pump plate
+**Adjust height of angle to allow hydraulic pump to stick 1" above bottom plane of the Power Cube
+**Tack weld angle to frame and mount plates to hydraulic tank
+**Place engine in position
+**Attach lovejoy coupler to engine
 [[Category:Fabrication Procedures]]