Ironworker/Manufacturing Instructions: Difference between revisions
Jump to navigation
Jump to search
m (moved Ironworker Build to Ironworker/Manufacturing Instructions) |
No edit summary |
||
| Line 1: | Line 1: | ||
=Introduction= | {{ToolTemplate|ToolName=Ironworker}} | ||
==Introduction== | |||
See [[Ironworkers]] for introduction. | See [[Ironworkers]] for introduction. | ||
=Build= | ==Build== | ||
We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate. | We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate. | ||
| Line 12: | Line 14: | ||
You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.] | You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.] | ||
=Design v0.1= | ==Design v0.1== | ||
[[Image:holepuncher01.jpg]] | [[Image:holepuncher01.jpg]] | ||
=Bill of Materials= | ==Bill of Materials== | ||
*5"x8" hydrauilic cylinder | *5"x8" hydrauilic cylinder | ||
*[2]1"x4" pin - for mounting cylinder | *[2]1"x4" pin - for mounting cylinder | ||
Revision as of 03:20, 23 August 2011
| Ironworker | ||
|---|---|---|
| Home | Research & Development | Bill of Materials | Manufacturing Instructions | User's Manual | User Reviews | 
| |
Introduction
See Ironworkers for introduction.
Build
We start the build of the open source ironworker with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.
Initial CAD, not finished:
You can download the file here.
Design v0.1
Bill of Materials
- 5"x8" hydrauilic cylinder
- [2]1"x4" pin - for mounting cylinder
- [2]3/4" or 1" washers
- [2] 1"x10"x48" plate - main parallel pieces
- [2] 1"x10"x32" plate - vertical supports
- [2] 1"x2"x3" plate - for reinforcement of pressing surface
- [4] 3/8"x4"x6" angle, 6" long - for legs
- [2] 1"x5"x5" plate - for alignment tube
- [2] 1"x4"x8" plate - for dye holders
- DOM tubing to hold die - 2" long
- Smaller DOM tubing to support die from underneath
- 2.5" DOM tubing, 5" long - for alignment
- 2.5" shaft, 7.7" long - for pressing
- 2.5" DOM tubing, 4" long - for main pin
- 2.5" shaft, 5" long - main pin
Notes: 1"x10" steel costs $233 if steel is 50 cents per pound.