User:Dorkmo/Builds/SteamEngine: Difference between revisions
< User:Dorkmo | Builds
Jump to navigation
Jump to search
| Line 43: | Line 43: | ||
[[Image:DorkmoSteamEngineHoleLocationPrintOut1.png|thumb|thansfer page]] | [[Image:DorkmoSteamEngineHoleLocationPrintOut1.png|thumb|thansfer page]] | ||
i think there are going to be 7 different sets. not sure if pages will be reusable after punching through? | |||
Revision as of 09:12, 30 November 2011
steam engine
hardware
- ace hardware
- nylon parts for copper spool
- all thread rod
- grainger
- aluminum tube spacer
- made in usa pipe fittings
software
thad - http://blog.brokensidewalkfarm.com/
progress
so far ive built a solenoid valve but i still need to test it. im slacking on that, theres a big air compressor i can use but its out in the country.
trying to figure out the final parts for piston and sleeve
- have to match up all the diameters of everything
90% i like these parts:
outer sleeve: 4-1/2" 12 gauge tube
brass sleeve: 104mm ID
piston ring: 241 teflon o-ring 1/8" thick
outer piston: 4" 12 gauge tube w/ .078" cut for ring to sit in
top of piston: steel plate, not sure yet
11/31/11
made a pattern to tranfer punch where holes are to be drilled
i think there are going to be 7 different sets. not sure if pages will be reusable after punching through?