Terminal Case

Introduction

A wide, low-profile case with a top lid and seal. Contains electronics. Ports at side for external wiring.

• Waterproof down to X meters

Versions

Version 4:

Screw fastening the lid would reduce the mounting volume of the terminal case considerably. But the trick is enabling screw fastening while retaining the ability to use C-Clamp compression too.

The cable glands are fine but there's a mounting issue where the aluminum is too thick for the short mounting thread of the cable gland. Also a multi-cable issue associated with fact that a cable gland can only seal properly with a single cable. Using some goop like silicone would work as a less modular solution- but only for the time being.

Welding technique: definitely weld the outside seams of the case because butt welds are far more straightforward than internal fillet welds. This also prevent slag from interfering with the electronics.

PCB Mounting technique: use spacers between the bottom of the PCB and the insulator plate so that short-circuiting is far less likely from any conductive thing getting down there.

Version 3:

File:Terminalcase31.jpg

File:Terminalcase34.jpg

Tools

TIG Welder with Argon Gas, Benchtop Grinder, and Proper Power Infrastructure

Cordless Drill, Clamps, Drill Bits

Small Grinder

Bandsaw

Materials

Aluminum Plate 1/4" x 7" (Speedymetals)

Aluminum Bar 1/4" x 3" (Speedymetals)

Pure Tan Gum Rubber 1/8" x 12" x 24"

---

Aluminum Plate 1/4" x 7" x 72" OR Aluminum Plate 1/4" x 12" x 36"

Aluminum Bar 1/2" x 3" x 72"

Pure Tan Gum Rubber 1/8" x 12" x 24"

Cable Gland

Build Documentation

Terminal Case CNC 1

Old Info

Version 2 with screw mounting:

Open Source Terminal Case File:Terminal-case.zip