Yoonseo Log: Difference between revisions
(→21) |
|||
| Line 26: | Line 26: | ||
http://www.irs.gov/uac/Free-File:-Do-Your-Federal-Taxes-for-Free | http://www.irs.gov/uac/Free-File:-Do-Your-Federal-Taxes-for-Free | ||
http://www.youtube.com/watch?annotation_id=annotation_286660&feature=iv&src_vid=mq7rkCcXkPk&v=MOIGaCaNnfM | |||
==20== | ==20== | ||
Revision as of 23:01, 22 December 2012
Future
December 2012
22
Started Tech Development as development scope with project granularization and timeline
21
Got Auto Insurance. Need to get and fax US driver's license and ontario driver's abstract to geico
Need to transfer vehicle under my name. Got non-assessment card. Truck needs inspection.
Need to take written and driving test at Maysville center on Thursday.
Got driver's abstract.
http://www.ontario.ca/driving-and-roads/uncertified-drivers-record
Research US tax process
http://www.irs.gov/uac/Free-File:-Do-Your-Federal-Taxes-for-Free
20
Applied for Auto Insurance... Talk to Maysville Local Insurance; if local insurance not good, call GEICO to finalize application
Researching US driver's license process... Call the Maysville licensing office again
Remember to transfer the vehicle under my name
Sealed door-side air gap at back of Hablab
Project Plan/Contract Discussion with Marcin
Working on Project Plan and Contract... Contract Draft 1 Complete. Project Plan Draft 1 Complete.
Progress on Development Guide - Assembly Mechanisms , Forming Mechanisms
TODO:
- Locate Plasma Cutter and Move to Torch Table
- Locate Gas Air Compressor and Move to Torch Table
- Connect Gas Compressor to Plasma Cutter
- Mount Plasma Cutter to Torch Table
- Clean and Organize Electronics Zone
- Assess CNC Electronics inventory
- Design CNC Electronics Mounting/Wiring Strategy
- Mount Steppers to CNC Case
- Wire CNC Case
- Wire CNC Electronics to Torch Table
19
Completed and Tested CEB Press Coded Arduino Board for Barry. Kavitha is taking care of shipping.
Room organizing.
Ordered some hand tools.
Getting ready for some post-organization CNC Torch Table rapid development. Straightforwardness is the key, baby!
Alas, there's a lot of workshop organization, tool acquisition, and supplier searching to be done.
C-Clamps should be made with flat perpendicular faces so that mounting C-Clamps on C-Clamps is easier. Plus flat faces make add-ons easier like welding on a linear rail. Oo, Fancy!
Ah, gotta do the truck legal stuff too.
18
Well, editing the wiki is so darn accessible. I'm going to try wiki-logging again.
CEB Press 1-Day Production Run
Development Guide is trudging along
Various tools still need to be ordered
Workshop needs to be cleaned up and super organized
Lead Free Brass Fitting and Fuse Holder order is still waiting on Marcin's response...