Lasersaur Exterior Panel Installation: Difference between revisions
Jump to navigation
Jump to search
(Created page with "==Mon 2 Jun 2014== It's important to note that when installing the Lasersaur's exterior skin, the factory-drilled holes differ in distance from the edge of the aluminum plate ...") |
No edit summary |
||
| Line 1: | Line 1: | ||
==Remaining Work on Lasersaur Assembly: 5 Jun 2014== | |||
*E-stop switch wiring needs to be rerouted to eliminate collision with exterior panels (see [http://www.lasersaur.com/manual/build-electronics Lasersaur Manual] | |||
*Door switch wiring needs to be rerouted to eliminate collision with plastic door panel (see same manual above) | |||
*Drill holes for exterior skin and plastic door panels as per [[Cris_Log_4]] model or [http://www.lasersaur.com/manual/build-frame-panels online manual] | |||
==Mon 2 Jun 2014== | ==Mon 2 Jun 2014== | ||
It's important to note that when installing the Lasersaur's exterior skin, the factory-drilled holes differ in distance from the edge of the aluminum plate by about 1mm. This means that one side will be closer to the edge of the frame (or if installed upside down may protrude beyond the edge of the frame). So, make sure the panel is not upside down when installing to eliminate any misalignment of panels. | It's important to note that when installing the Lasersaur's exterior skin, the factory-drilled holes differ in distance from the edge of the aluminum plate by about 1mm. This means that one side will be closer to the edge of the frame (or if installed upside down may protrude beyond the edge of the frame). So, make sure the panel is not upside down when installing to eliminate any misalignment of panels. | ||
See the [http://www.lasersaur.com/manual/build-frame-panels Lasersaur Manual online] to see where the additional holes should be drilled on the panels and plastic door panels, or see [[Cris Log]] | See the [http://www.lasersaur.com/manual/build-frame-panels Lasersaur Manual online] to see where the additional holes should be drilled on the panels and plastic door panels, or see [[Cris Log]] | ||
Revision as of 19:37, 5 June 2014
Remaining Work on Lasersaur Assembly: 5 Jun 2014
- E-stop switch wiring needs to be rerouted to eliminate collision with exterior panels (see Lasersaur Manual
- Door switch wiring needs to be rerouted to eliminate collision with plastic door panel (see same manual above)
- Drill holes for exterior skin and plastic door panels as per Cris_Log_4 model or online manual
Mon 2 Jun 2014
It's important to note that when installing the Lasersaur's exterior skin, the factory-drilled holes differ in distance from the edge of the aluminum plate by about 1mm. This means that one side will be closer to the edge of the frame (or if installed upside down may protrude beyond the edge of the frame). So, make sure the panel is not upside down when installing to eliminate any misalignment of panels.
See the Lasersaur Manual online to see where the additional holes should be drilled on the panels and plastic door panels, or see Cris Log