Kostas Latoufis

• 800 euro - 2.4m diameter rotor - 600W maximum 10m/s. 5 m/s has around - 110 Watts +/-20W
• Axial flux design
• 30 cm diameter, disk, steel
• RPM at 10 m/s 400 rpm
• need thickness so you don't saturate the iron
• Permanent deflection happens for larger
• 1200 kwh 5m/s. about 3 kwhr/day
• Equivalent to a 500W solar array equivalent
• 30% efficiency wind to batteries, not including charging loss of batteries.
• Generator designs are 87% and down to 80% as power increases. Need more magnets, then need less copper in stator.
• Direct connect to battery - no maximum power point tracking
• To connect to existing system - 300 Euro for tower/guy wires/concrete if necessary if no big rocks. 100Euro for cable. Diversion charge controller - goes to a resistor if too much - 250 euro - and resistor is $250 euro. Resistor is a thin wire wound around a metal cylinder for good heat dissipation. Surge power of 1kW of resistor.
• Solar panels - just mounting structure + charge controller - $100
• Magnets themselves cost - 10 euro per piece - need 24. 5 euro in bulk - 100 MOQ.
• No iron core for
• Powdered iron mixed in the resin - so you concentrate electric field in the core. For same amount of magnet, get more power. Typically lower efficiency when you have a core, but higher power density. With core, may be down to 75% efficient.
• Core generator has cooling - fan on rotor.
• Coreless is more expensive
• Similar to [1] - larger ones - [2]. 760 kg for 30kw.
• ST generator head - 20kw - 365 lb -- $800 - http://www.ebay.com/itm/20KW-ST-Generator-Head-1-Phase-for-Diesel-or-Gas-Engine-60Hz-/331914210831. Compare to 585 lb for radial flux - http://www.ginlong.com/en/Wind_Products/GL_PMG_20K.html
• [3] -
• Hugh - it works, but it's time for the next step.
• Hydro turbine - Turgorunner open source design, 3d printed runners. There's a guy in the USA who does turbine work.
• What are the collaborative design tools.
• Max in Germany makes blades in 2 hours. He is a fun guy.