Talk:MicroTrac Controller v17.10: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(→‎wire routing: new section)
(→‎GPS Module: new section)
Line 71: Line 71:
*putting two 18 gauge wires into one relay module terminal block is tricky.
*putting two 18 gauge wires into one relay module terminal block is tricky.
**could have switch wire and trailer plug wire meet at a crimp connector then have one wire go to relay module
**could have switch wire and trailer plug wire meet at a crimp connector then have one wire go to relay module
== GPS Module ==
http://www.doctormonk.com/2012/05/sparkfun-venus-gps-and-arduino.html
Three pins on GPS module GRND, 3.3V, TX

Revision as of 18:30, 28 October 2017

Wireless Communication Options

  • Arduino's official wifi shield is discontinued
  • Could use xbee radio w/ shield
  • Arduino MKR WAN 1300 link
    • new board for arduino, comes out in november

Remote Control Arduino Examples

Xbee Examples


Control

  • Relay Board Controlled
    • left side forward
    • left side reverse
    • right side forward
    • right side reverse
    • main arm up
    • main arm down
    • bucket up
    • bucket down
    • engine start
    • engine kill
    • auxillary
    • auxillary
  • choke - linear actuator?
  • trottle potentiometer - linear actuator?

Actuators

Input Devices and Switches

Relay Boards

Relay Module

Wire Connections

Trailer Connections

  • 4-way Knockout mounted connector grainger
    • these would look nice on a box. no dimensions listed online. hole size?

Radio Coax Cable Connections

see https://en.wikipedia.org/wiki/SMA_connector#Reverse_polarity

wire routing

  • putting two 18 gauge wires into one relay module terminal block is tricky.
    • could have switch wire and trailer plug wire meet at a crimp connector then have one wire go to relay module

GPS Module

http://www.doctormonk.com/2012/05/sparkfun-venus-gps-and-arduino.html

Three pins on GPS module GRND, 3.3V, TX