MicroTrac Controller v17.10: Difference between revisions
Jump to navigation
Jump to search
| Line 49: | Line 49: | ||
[https://docs.google.com/drawings/d/1IHwVqvpGYt3wcil_wunRvYVX0QkG-6qgIz6IdO4Wvyo/edit gdrive] | [https://docs.google.com/drawings/d/1IHwVqvpGYt3wcil_wunRvYVX0QkG-6qgIz6IdO4Wvyo/edit gdrive] | ||
===Wire Harnesses=== | |||
[https://docs.google.com/drawings/d/11G6lN_UvayLDRcjpAcJqac7PM-1csi2X7SKfj_lfOWg/edit gdrive] | |||
=Future Work= | =Future Work= | ||
Revision as of 21:02, 28 October 2017
Used to control the hydraulic system of MicroTrac.
See the arduino code that runs inside this controller box.
Goals
- Remotely control solenoid valves
- Transmit signals from remotely located control box to onboard control box
- Broadcast GPS location and compass heading from MicroTrac
- Determine suitability of different wireless standards and hardware
- Wifi Shield
- xbee long range
Tentative BOM
- Arduino Mega
- xbee Long Range mouser
- Arduino wireless shield mouser arduino store
- 8 Channel Relay Module
- (4) 6P DPST toggle switch grainger
- (5) 4-way Trailer Connector Grainger
- GPS Module Sparkfun
- GPS Antenna Sparkfun
- Compass breakout board sparkfun
- Logic Converter Sparkfun
- (2) RP-SMA F-M Cable digikey
- 900Mhz Antenna Sparkfun
Wiring Diagram
Controller Box
Wiring Harnesses
Onboard Box
Wire Harnesses
Future Work
- Remotely control throttle
- Remotely shut down or start engine
- Integrate with GPS functionality