D3D 1612 Product Manual: Difference between revisions
Jump to navigation
Jump to search
| Line 2: | Line 2: | ||
=Operation= | =Operation= | ||
=Troubleshooting= | =Troubleshooting= | ||
*Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of [[D3D_Controller#Wiring]] | *Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of [[D3D_Controller#Wiring]] or the slide that has the thermistor wire detail. | ||
=Repair= | =Repair= | ||
Revision as of 01:55, 11 January 2018
Safety
Operation
Troubleshooting
- Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of D3D_Controller#Wiring or the slide that has the thermistor wire detail.