D3D 1612 Product Manual: Difference between revisions
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
*Note that configuration.h in Arduino code does not set bed size, but only the software endstops. | *Note that configuration.h in Arduino code does not set bed size, but only the software endstops. | ||
*Use 3 point probing in OSE Marlin. | *Use 3 point probing in OSE Marlin. | ||
*To modify | *To modify probing location, go to Arduino IDE->configuration.h -> | ||
[[File:d3d1612probingloc.jpg]] | |||
=Troubleshooting= | =Troubleshooting= | ||
Revision as of 23:35, 15 January 2018
Safety
Operation
Setting Bed Leveling Probing
- For D3D 1612 - set the following coordinates:
- Note that configuration.h in Arduino code does not set bed size, but only the software endstops.
- Use 3 point probing in OSE Marlin.
- To modify probing location, go to Arduino IDE->configuration.h ->
Troubleshooting
- Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of D3D_Controller#Wiring or the slide that has the thermistor wire detail.