Revision as of 14:14, 20 April 2019

Overview

Building a small machine to test sock size fabric

@@ Line 11: / Line 11: @@
 =Log=
+==April 19, 2019==
+*got lasercut parts
+*assembled machine
+**new mountain design idea is not able to be removed easily
+***have to remove needles or disassemble plates
+**claws on p4 yarn holder have holes that are relatively too big
+***bottom side is snapping off on the outer hole
+**aluminum angle iron holder needs some tweaking
+***when tightened all the way, begins to expand and let go around corner
+***maybe trim less on the internal side, make wiggle room larger
+***coud possible have a square nut in mountain to insert bolt on side
+***change to square nuts for back side, have to dissasemble machine to insert 30mm bolt
+**Need to make nut insert on Z bearing holder a little bigger
 ==April 16, 2019==