Revision as of 20:39, 18 May 2020

Basics

An alternatice to the Precious Plastic Shredder that works with bottles, or hollow containers, and shears/scissors
The user:
- Places the container on the verticle rod of the Peeling Module , lining the bottom edge with the v slit before the angled blade
- They then either use a Rotator Module , or just manually do it (most likely option), and spin it
- This produces a ~0.5-1cm plastic "peel"
- This can be used as is, or be cut into small squares/flakes, resulting in a similar product to that of the shredder
If the manual version is chosen, this can all be done with no power, and little setup cost
The peel can also be made into a rope (not sure on quality) which should be easier to work with than natural fiber rope if none other is available (melt frayed ends, instead of havving to cut/manually splice them ( User:Eric does small boat sailing, plastic rope is a modern miracle...), also may be easier to mass produce small scale (only need plastic bottles, not long natural/semi-synthetic fibers

@@ Line 3: / Line 3: @@
 *The user:
 **Places the container on the verticle rod of the '''Peeling Module''' , lining the bottom edge with the v slit before the angled blade
-**They then either use a ''"Rotator Module''' , or just manually do it (most likely option), and spin it
+**They then either use a '''Rotator Module''' , or just manually do it (most likely option), and spin it
 **This produces a ~0.5-1cm plastic "peel"
 **This can be used as is, or be cut into small squares/flakes, resulting in a similar product to that of the shredder