Dirk 3D Printed Electric Motor Data Collection: Difference between revisions
Jump to navigation
Jump to search
(Created page with " *Did a 2-rotor, 1 stator version *Went to 6 volts - current draw for 2-rotor (1 stator) version *12V at 2.5A. 200 hz frequency. 30W usage. *6 meters wound per coil *Should b...") |
No edit summary |
||
| Line 9: | Line 9: | ||
*Would self-start by turning frequency dial on controller several times. | *Would self-start by turning frequency dial on controller several times. | ||
*It hummed when not started | *It hummed when not started | ||
=Links= | |||
[[Dirk's Electric Motor]] | |||
Latest revision as of 22:56, 1 August 2020
- Did a 2-rotor, 1 stator version
- Went to 6 volts - current draw for 2-rotor (1 stator) version
- 12V at 2.5A. 200 hz frequency. 30W usage.
- 6 meters wound per coil
- Should be 12 wires of 3 meters - for more power draw.
- Didn't even get warm
- Was looking for optimal frequency - no feedback used.
- Would self-start by turning frequency dial on controller several times.
- It hummed when not started