Assemble Power Cube: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 11: | Line 11: | ||
**Torch engine mount plate pattern- best is plasma cutter | **Torch engine mount plate pattern- best is plasma cutter | ||
**Torch hydraulic pump mount plate pattern | **Torch hydraulic pump mount plate pattern | ||
**Tack weld angle to frame and mount plates to hydraulic tank | **Tack weld angle to frame and mount plates to hydraulic tank | ||
**Place engine in position | **Place engine in position | ||
**Attach lovejoy coupler to engine | **Attach lovejoy coupler to engine | ||
**Adjust height of angle to allow hydraulic pump to stick 1" above bottom plane of the Power Cube | |||
[[Category:Fabrication Procedures]] | [[Category:Fabrication Procedures]] | ||
Revision as of 00:57, 19 June 2011
- Weld frame using jig.
- Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube.
- Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame.
- Mount Engine and Pump:
- Trim engine shaft to 2"
- Put hydraulic fittings on hydraulic pump, and connect lovejoy coupler to pump
- [1] Cut plate for Engine Mount - 1/4"x8"x20"?
- [1] Cut plate for hydraulic pump - 1/4"x8"x?
- [1] Cut 1/4"x8"x3"? connecting plate
- [1] Cut 1/4"x2" angle for Power Cube Mount
- Torch engine mount plate pattern- best is plasma cutter
- Torch hydraulic pump mount plate pattern
- Tack weld angle to frame and mount plates to hydraulic tank
- Place engine in position
- Attach lovejoy coupler to engine
- Adjust height of angle to allow hydraulic pump to stick 1" above bottom plane of the Power Cube