Assemble Power Cube: Difference between revisions

Revision as of 00:59, 19 June 2011

Weld frame using jig.
Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube.
Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame.
Mount Engine and Pump:
- Trim engine shaft to 2"
- Put hydraulic fittings on hydraulic pump, and connect lovejoy coupler to pump
- [1] Cut plate for Engine Mount - 1/4"x8"x20"?
- [1] Cut plate for hydraulic pump - 1/4"x8"x?
- [1] Cut 1/4"x8"x3"? connecting plate
- [1] Cut 1/4"x2" angle for Power Cube Mount
- Torch engine mount plate pattern- best is plasma cutter
- Torch hydraulic pump mount plate pattern
- Measure distance from bottom of pump to bottom plane of engine
- Use this measurement to determine height of engine mount plate in frame
- Tack weld angle to frame
- Tack weld engine mount plate to hydraulic tank and angle
- Place engine in position
- Attach lovejoy coupler to engine
- Adjust height of angle to allow hydraulic pump to stick 1" above bottom plane of the Power Cube

@@ Line 11: / Line 11: @@
 **Torch engine mount plate pattern- best is plasma cutter
 **Torch hydraulic pump mount plate pattern
-**Tack weld angle to frame and mount plates to hydraulic tank
+**Measure distance from bottom of pump to bottom plane of engine
+**Use this measurement to determine height of engine mount plate in frame
+**Tack weld angle to frame
+**Tack weld engine mount plate to hydraulic tank and angle
 **Place engine in position
 **Attach lovejoy coupler to engine