Ironworker/Manufacturing Instructions: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
Line 1: Line 1:
=Introduction=
{{ToolTemplate|ToolName=Ironworker}}
 
==Introduction==


See [[Ironworkers]] for introduction.
See [[Ironworkers]] for introduction.


=Build=
==Build==
We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.
We start the build of the ''open source ironworker'' with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.


Line 12: Line 14:
You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.]
You can download the file [http://openpario.mime.oregonstate.edu:3000/documents/96 here.]


=Design v0.1=
==Design v0.1==


[[Image:holepuncher01.jpg]]
[[Image:holepuncher01.jpg]]


=Bill of Materials=
==Bill of Materials==
*5"x8" hydrauilic cylinder
*5"x8" hydrauilic cylinder
*[2]1"x4" pin - for mounting cylinder
*[2]1"x4" pin - for mounting cylinder

Revision as of 03:20, 23 August 2011


Ironworker
   Home  |  Research & Development  |  Bill of Materials  |  Manufacturing Instructions  |  User's Manual  |  User Reviews    Ironworker.png


Introduction

See Ironworkers for introduction.

Build

We start the build of the open source ironworker with a 120 ton hole puncher for poking up to 1.5 inch holes in 1" steel (figure based on Edwards ironworkers) plate.

Initial CAD, not finished:

Holepuncher.jpeg

You can download the file here.

Design v0.1

Holepuncher01.jpg

Bill of Materials

  • 5"x8" hydrauilic cylinder
  • [2]1"x4" pin - for mounting cylinder
  • [2]3/4" or 1" washers
  • [2] 1"x10"x48" plate - main parallel pieces
  • [2] 1"x10"x32" plate - vertical supports
  • [2] 1"x2"x3" plate - for reinforcement of pressing surface
  • [4] 3/8"x4"x6" angle, 6" long - for legs
  • [2] 1"x5"x5" plate - for alignment tube
  • [2] 1"x4"x8" plate - for dye holders
  • DOM tubing to hold die - 2" long
  • Smaller DOM tubing to support die from underneath
  • 2.5" DOM tubing, 5" long - for alignment
  • 2.5" shaft, 7.7" long - for pressing
  • 2.5" DOM tubing, 4" long - for main pin
  • 2.5" shaft, 5" long - main pin

Notes: 1"x10" steel costs $233 if steel is 50 cents per pound.