User:Dorkmo/Builds/SteamEngine: Difference between revisions
< User:Dorkmo | Builds
Jump to navigation
Jump to search
(Created page with "steam engine ==hardware== *ace hardware :*nylon parts for copper spool :*all thread rod *grainger :*aluminum tube spacer :*made in usa pipe fittings ==software== thad - http://...") |
|||
| Line 20: | Line 20: | ||
trying to figure out the final parts for piston and sleeve | trying to figure out the final parts for piston and sleeve | ||
:have to match up all the diameters of everything | :have to match up all the diameters of everything | ||
90% i like these parts: | |||
outer sleeve: 4-1/2" 12 gauge tube | |||
brass sleeve: 104mm ID | |||
piston ring: 241 teflon o-ring 1/8" thick | |||
outer piston: 4" 12 gauge tube w/ .078" cut for ring to sit in | |||
top of piston: steel plate, not sure yet | |||
Revision as of 08:15, 20 November 2011
steam engine
hardware
- ace hardware
- nylon parts for copper spool
- all thread rod
- grainger
- aluminum tube spacer
- made in usa pipe fittings
software
thad - http://blog.brokensidewalkfarm.com/
progress
so far ive built a solenoid valve but i still need to test it. im slacking on that, theres a big air compressor i can use but its out in the country.
trying to figure out the final parts for piston and sleeve
- have to match up all the diameters of everything
90% i like these parts: outer sleeve: 4-1/2" 12 gauge tube
brass sleeve: 104mm ID
piston ring: 241 teflon o-ring 1/8" thick
outer piston: 4" 12 gauge tube w/ .078" cut for ring to sit in
top of piston: steel plate, not sure yet