User:Dorkmo/Builds/SteamEngine: Difference between revisions
| Line 44: | Line 44: | ||
[[Image:DorkmoSteamEngineHoleLocationPrintOut1.png|thumb|thansfer page]] | [[Image:DorkmoSteamEngineHoleLocationPrintOut1.png|thumb|thansfer page]] | ||
there should end up being seven different sets. not sure if pages will be reusable after punching through? | |||
need to put a ruler on the printouts so peeps can verify they printed to the right size. | |||
Revision as of 09:15, 30 November 2011
steam engine
hardware
- ace hardware
- nylon parts for copper spool
- all thread rod
- grainger
- aluminum tube spacer
- made in usa pipe fittings
software
thad - http://blog.brokensidewalkfarm.com/
progress
so far ive built a solenoid valve but i still need to test it. im slacking on that, theres a big air compressor i can use but its out in the country.
trying to figure out the final parts for piston and sleeve
- have to match up all the diameters of everything
90% i like these parts:
outer sleeve: 4-1/2" 12 gauge tube
brass sleeve: 104mm ID
piston ring: 241 teflon o-ring 1/8" thick
outer piston: 4" 12 gauge tube w/ .078" cut for ring to sit in
top of piston: steel plate, not sure yet
11/31/11
made a pattern to tranfer punch where holes are to be drilled
there should end up being seven different sets. not sure if pages will be reusable after punching through?
need to put a ruler on the printouts so peeps can verify they printed to the right size.