User:Dorkmo/Builds/SteamEngine: Difference between revisions
| Line 39: | Line 39: | ||
11/31/11 | 11/31/11 | ||
[[Image:DorkmoSteamEngineHoleLocationPrintOut1.png|thumb|thansfer page]] | |||
made a pattern to tranfer punch where holes are to be drilled | made a pattern to tranfer punch where holes are to be drilled | ||
[[ | [[https://docs.google.com/leaf?id=0BwxMMqGvwTM-ZDBiYjVjNzItMDEyZS00MmRkLWI2OWQtZTVmMThkMTgzNzA4&hl=en_US]] | ||
there should end up being seven different sets. not sure if pages will be reusable after punching through? | there should end up being seven different sets. not sure if pages will be reusable after punching through? | ||
need to put a ruler on the printouts so peeps can verify they printed to the right size. | need to put a ruler on the printouts so peeps can verify they printed to the right size. | ||
Revision as of 09:22, 30 November 2011
steam engine
hardware
- ace hardware
- nylon parts for copper spool
- all thread rod
- grainger
- aluminum tube spacer
- made in usa pipe fittings
software
thad - http://blog.brokensidewalkfarm.com/
progress
so far ive built a solenoid valve but i still need to test it. im slacking on that, theres a big air compressor i can use but its out in the country.
trying to figure out the final parts for piston and sleeve
- have to match up all the diameters of everything
90% i like these parts:
outer sleeve: 4-1/2" 12 gauge tube
brass sleeve: 104mm ID
piston ring: 241 teflon o-ring 1/8" thick
outer piston: 4" 12 gauge tube w/ .078" cut for ring to sit in
top of piston: steel plate, not sure yet
11/31/11
made a pattern to tranfer punch where holes are to be drilled
[[1]]
there should end up being seven different sets. not sure if pages will be reusable after punching through?
need to put a ruler on the printouts so peeps can verify they printed to the right size.