User:Dorkmo/Builds/SteamEngine: Difference between revisions
| Line 50: | Line 50: | ||
need to put a ruler on the printouts so peeps can verify they printed to the right size. | need to put a ruler on the printouts so peeps can verify they printed to the right size. | ||
12/1/11 | |||
spooled two more solenoids. need to get more nylon washers for #4. | |||
need to find online retailer for nylon stuff | |||
Revision as of 08:43, 1 December 2011
steam engine
hardware
- ace hardware
- nylon parts for copper spool
- all thread rod
- grainger
- aluminum tube spacer
- made in usa pipe fittings
Engine Management System
progress
so far ive built a solenoid valve but i still need to test it. im slacking on that, theres a big air compressor i can use but its out in the country.
trying to figure out the final parts for piston and sleeve
- have to match up all the diameters of everything
90% i like these parts:
outer sleeve: 4-1/2" 12 gauge tube
brass sleeve: 104mm ID
piston ring: 241 teflon o-ring 1/8" thick
outer piston: 4" 12 gauge tube w/ .078" cut for ring to sit in
top of piston: steel plate, not sure yet
11/31/11
made a pattern to tranfer punch where holes are to be drilled
[[1]]
there should end up being seven different sets. not sure if pages will be reusable after punching through?
need to put a ruler on the printouts so peeps can verify they printed to the right size.
12/1/11
spooled two more solenoids. need to get more nylon washers for #4.
need to find online retailer for nylon stuff