Bulldozer QC

• bolt heads do not have washer on outside connection of Rotor to frame
• at least 3 bolts connect on top from rotor to frame.
• At least 2 bolts connect idler mount plates to frame
• correct spacing for idler is determined by track pads being 2" away from frame and bolts
• spacer is inserted between inner bearing of idler and frame
• Idler shaft sticks out one foot on one side and a minimum on the other side - just enough to put a 2"clamp on outside the bearing
• bolts on the 6" idler clamps are tight to 300 in lb- see bolt torque table
• sprocket clamps are tight to 300 in lb
• no airspace is visible between idler mount plates and frame/rotor
• track tensioner is against the idler mount plate
• main idler shaft clamps are touching the u-bolt
• 2 Microtractor are mirror images for symmetry, exhaust, and excess idler shaft reasons.
• offset cab is allowed
• tying 2 Microtractor at front is done with two 10' tubes
• trailer hitch mounts third power cube in back.