Talk:Oliver Log

Mon, May,22,2017

Preparation for torchtable-workgroup meeting on 23.05.:

Suggestions for the long axis:

- supportet Rails [1] would be nice for better stiffness and rigidity, . Makes a price difference of about 20,- EUR or less per m .

* Instead of one 1"-shaft we could use two 1/2"-shafts to resemble the recent unversal axis design as is.

* Or instead we can use just one 1"-shaft and place the stepper onto the carriage (like shapeoko) 
  ==> simplyfied end-pieces (they are only needed to fix the belt).

- Universal Controler: Powerlolu as stepperdriver for heavier loads ?

* Was already discussed on OSE in 2013, see [2]

* sources are available at 
  GitHub [3] and 
  Upverter [4] and
  Allegro [5] and
  Cuteminds [6] and
  Balestrino [7].  

* new breakout board from OSH park at [8]

* I tested them already [9] [10] in combination with RAMPS and so far they seemed to work well.