D3D 1612 Product Manual
Jump to navigation
Jump to search
Safety
Operation
Setting Bed Leveling Probing
- For D3D 1612 - set the following coordinates:
- Use 3 point probing in OSE Marlin.
- To modify settings, go to Arduino IDE->
Troubleshooting
- Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of D3D_Controller#Wiring or the slide that has the thermistor wire detail.