D3D v20.04.27 Build Instructions

From Open Source Ecology
Revision as of 20:33, 4 May 2020 by Marcin (talk | contribs)
Jump to navigation Jump to search

Bed

Heater


  1. Cut 4" fence wire transition pieces, wrap nichrome around them

Z Axis

  1. Assemble idler side.
  2. Mount idler side on bottom of frame, right next to corner piece, with nuts next to frame.
  3. Assemble carriage side.
  4. Open idler side, keeping it mounted on frame. This will allow fitting of axis to it.
  5. Mount motor side on rods, keep loose.
  6. Fit motor side to frame, hanging it on the top of the frame, and adjusting rod lengths so they are slightly above the working surface.
  7. Take off axis, mount motor, tighten motor side fully.
  8. Mount motor side on frame, and in idler.
  9. Close the idler side.
  10. One axis mounted. Now mount 3 more.

Links

Retrieved from "https://wiki.opensourceecology.org/index.php?title=D3D_v20.04.27_Build_Instructions&oldid=219517"