D3D Lulzbot Cura

Introduction

Lulzbot Cura allows for ready setup of machines other than Lulzbot and Lulzbot Mini. As such, it is useful to use Lulzbot Cura for OSE's D3D 3D Printer.

By going to Expert-> Switch to Full Settings - you can set nozzle size and various parameters. Once all configuration has been input, you can save the profile as a .ini file.

To configure a new machine (bed size) go to the menu - Machine-> Add New Machine - you can add a profile for the D3D Original - 8" print bed.

Files

Configuration (.ini) file for D3D Lulzbot Cura:

File:D3DOriginal config.ini - D3D Original, 16" frame, 8" print bed, 0.5" nozzle.

Calibration

From Triffid Hunter's Calibration Guide:

Start with D3D BOM - the pulleys are 20 tooth?

Yes, and the magic number is 80 steps/mm for x, y, and z.

Doing a 100 mm extrusion in Pronterface yielded 4.6 times that length! The Extruder steps/mm are 4.6 too high. Reduce them accordingly. Go to D3D Marlin.