D3D 1612 Product Manual

From Open Source Ecology

Revision as of 01:55, 11 January 2018 by Marcin (talk | contribs) (→‎Troubleshooting)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to navigation Jump to search

Safety

Operation

Troubleshooting

Heaters refversed in Cura. If you set the extruder temperature - and notice that the heatbed temperature is rising instead - then the order of the thermistors has been reversed. Move the extruder thermistor to the connector closer to the power plug on the RAMPS board. See Slide 4 of D3D_Controller#Wiring

Repair

Retrieved from "https://wiki.opensourceecology.org/index.php?title=D3D_1612_Product_Manual&oldid=163566"