D3D v20.04.27 Future Work
Jump to navigation
Jump to search
Future Work
Specific Immediate Items
- Simplify Universal Axis from clamshell to monolithic for Motor and idlder side.
- Retain carriage side, or fix it? Only compelling reason is taking the X axis off. But we could redesign the X so it can be independent of the Y. If we take off X with 2 bolts, service on X or Y allows for whole X and Whole Y to be taken off easily - the Y does not mix with X.
- Put a 6 mm set screw hole into the bottom z axis holder so it doesn't slip when moving the printer. It holds against the stop of the clip.
Production Engineering
- Too much cleanup on X-Y joints. Rework the production engineering so that printing can be by default more clean. Probably do a joint between one-piece motor and one-piece carriage.
- Is any of this due to print settings and/or nozzle size?
- Get a shear for cutting PEI easily
Cleanup
- Wiring - desing snap-in wire clips - snap in to frame, no tape needed.
- Banana Connectors perhaps?
Later Work
- Develop FDM 3D Printer Print Profiles for various materials to make it even more plug and play (less, if any failed prints due to the best settings being pre-determined)
- D3D Toolchanger and/or D3D Toolheads
Bug Reports
- fix the Y carrieage to X pieces so both carriages are external.