Assemble Power Cube

• Weld frame using jig.
• Weld hydraulic tank onto frame, with suction strainer assembly in place. Orientation faces the operator when looking backwards at the Power Cube.
• Weld fuel tank to frame. Orientation is away from operator (safety) on the rear left corner of frame.
• Mount Engine and Pump:
  • Trim engine shaft to 2"
  • Put hydraulic fittings on hydraulic pump, and connect lovejoy coupler to pump
  • [1] Cut plate for Engine Mount - 1/4"x8"x20"?
  • [1] Cut plate for hydraulic pump - 1/4"x8"x?
  • [1] Cut 1/4"x8"x3"? connecting plate
  • [1] Cut 1/4"x2" angle for Power Cube Mount
  • Torch engine mount plate pattern- best is plasma cutter
  • Torch hydraulic pump mount plate pattern
  • Adjust height of angle to allow hydraulic pump to stick 1" above bottom plane of the Power Cube
  • Tack weld angle to frame and mount plates to hydraulic tank
  • Place engine in position
  • Attach lovejoy coupler to engine