General Processes/Circuit Etching

There are a few different ways to etch a circuit board. if you'd like to add a different style please feel free add a section.

Toner Transfer

make circuit board (you can mill the board or follow the instructions here to use a laser printer and etching)

print the mirrored image on laser photo paper

tape the paper onto the copper board

using a laundry iron, heat the paper until discolored

soak in water and peel the paper away

agitate in pcb etchant solution for 20-30 min until copper is gone

using a #58 drill bit and drill press, drill all the holes

apply accetone to a cloth and wipe away toner

check and fix errors

places where not enough was etched away or where too much was