User talk:Tom Griffing
Power Cube as a stressed member
Howdy Tom, I couldn't figure out any other way to send you a message. What do you think about the idea of beefing up the Power Cube and working out a set of standardized mounting points (lugs?) so that it could become a stressed member of the vehicles it's incorporated into? Not necessarily integral to the vehicle frame holding together, but at least stressed enough that it replaces some metal in the frame. It's not like the vehicle's going anywhere without a power cube anyway.
Suction Hose Sizing
did u mention that there were some changes made to the lines going to the pump on the power cube? i was thinking that it might be good to change the hydraulic tank design so that the output is on the other side? last time i saw the hose looped around from one side to the other, i wasnt sure if thats what you had tweeked but just throwing the idea into the mix --Dorkmo 23:50, 30 August 2011 (CEST)
Sorry for the delayed reply - I'm just now figuring how to use User Talk. Yes, I'm changing the line going to the pump - increasing it to 1" diameter. The calculations for the hose size is on the following page:
Power Cube Tools
Can you tell me what tools are required to build a power cube? I don't mean the parts for the cube itself, but the tools used to build one. I am working on setting up a shop in my garage --RootBeer 00:17, 26 November 2011 (CST)
Here's my list from memory - I will probably add to it in time. Craigslist and Ebay are handy for finding used tools.
- Cutting torch - capable of cutting 1/2" steel. If you plan on building a LifeTrac, get one that can cut 1" steel. I bought mine at Home Depot.
- Vise Grip Pliers - Two or three pair
- 6" C Clamps - Two should be sufficient
- Metal Saw - I bought a DeWalt DW872, but anything that can cut 2" x 2" angle iron
- Drill and bits - 9/16" bit and a regular assortment of smaller bits
- Angle Grinder - I bought a 4" and a 7" and use them both
- Welder - You may have a preference, but after using the MillerMatic 200 MIG at FeF and now a small TIG, I prefer the more expensive Millermatic
- Welding Table - A steel table is helpful, but not necessary
- Chalk Marker - Important for marking steel to cut with torch
- Safety Equipment - Welding helmet, ear protection, safety glasses, steel toe boots, gloves, long sleeve shirt for welding
- Wrenches - Several sizes, including 3/4"
- Hex Keys - For the coupling set screws
- Tape Measure - Two, as one is always misplaced
- Paint Sprayer / Air Compressor - FeF used a gravity fed sprayer